Fig Pruning and Training in Years 1-2 | Tips for Young Tree Shaping and Main Branch Selection
Updated: 2026-10-06
Pruning newly planted figs using the same methods applied to mature trees can result in uneven branching and failure to establish a strong central leader. During the first one to two years after planting, the focus should be on building the tree's framework rather than pursuing an early harvest. Performing winter heading cuts followed by summer shoot thinning in sequence establishes the foundation for the tree form that will be used for many years afterward. This article outlines the key pruning and training practices specific to young trees, organized by the first and second years after planting.

Winter of the First Year After Planting — Cut Back the Main Trunk Low
After planting a sapling, cut back the main stem to a height of 30–50 cm above ground during the first winter. Leaving the stem at a greater height and allowing it to grow results in higher branch positions in the future, which makes harvesting and winter protection work more difficult. Beginning in spring, multiple buds will break from just below the cut surface.
First Summer — Selecting Branches to Retain from New Growth
New shoots that begin extending from spring will become crowded as multiple stems compete if left unmanaged. From the budbreak branches, retain 3 to 4 of the most vigorous shoots, and remove early any branches growing inward or those that are extremely thin. Thinning at this stage allows the retained branches to develop sturdy diameter by autumn, making them suitable candidates for primary scaffold branches the following year.
Year Two Winter — Definitively Select the Main Framework Branches
In the second winter, formally select three to four branches from those retained in the first year to serve as future main branches. Selection criteria are as follows:
- Branches positioned with even spacing between them and no interference with one another
- Branches of moderate vigor—neither excessively thick nor too thin.
- Branches that spread from the main trunk at a moderate angle—neither too narrow (not growing straight upward) nor too wide.
Remove all primary branches except the one selected, and cut back the tip of the remaining primary branch to approximately one-third to one-half of its length depending on tree vigor, preparing to increase the number of branches for the following year.
From Year Two Onward — Choosing a Training System
Once the main branches are established, train the branches into a central-leader form, open-center form, espalier, or other shape according to garden size and harvest accessibility. When uncertain about training method, consult the variety guide or forum to learn how others train their figs.
Pruning Mistakes to Avoid on Young Trees
- Retaining all branches that grew during summer in hopes of hastening harvest.
- Hesitating to cut back the main trunk and allowing it to grow tall without heading.
- Pruning too heavily in winter can result in removal of branches needed for fruiting in the following year.
For the first one to two years of a young tree, establishing the framework takes priority over fruit production. Cut back the central leader low in the first winter, thin the new shoots in summer, and establish the primary branches in the second winter. Following this sequence alone will make pruning significantly easier from the third year onward. Building a solid foundation without rushing is the most efficient approach to establishing a tree for long-term cultivation.
Not sure what your fig is?
Post a photo of the leaves and fruit and see what other growers think. "Maybe" is a perfectly good answer here.
Post your figNot going the way you hoped?
Ask other growers on the board. A photo gets you a faster answer.